Product Information Bonnets Two piece moulded bonnet - inner and outer skins intergrated High - Strength, high performance Weld-On brand adhesive used to glue the two skins together to provide stiffness while maintaining some flexibility to handle vibrations and stresses of driving Hand laid FRP constuction for superior quality Best quality gelcoat used for superior paint adhesion Air intake and outlet flutes designed to allow for efficient cooling of the engine bay - air outlet flute is located at the rear of the bulge Water is directed to 4 outlet holes built into innerside of the bonnet easily removing any water that may enter the engine bay New designed one piece smooth finished underside Reinforcing plates for hinges, gas strut mounts and bonnet latch Weight approximately - 17kg - suits standard gas struts Please Note - We are moving to a New Factory during December and Early January. We will not have any products available until the end of January 2009 due to the move. You can pre-order with a $500 deposit To View Products - Click on one of following    $990.00 -  GST Inclusive + Freight - pricing quoted in Australia Dollars  $1425.00 - GST Inclusive + Freight - pricing quoted in Australia Dollars  $1525.00 - GST Inclusive + Freight - pricing quoted in Australia Dollars  $1325.00 - GST Inclusive + Freight - pricing quoted in Australia Dollars  $1625.00 - GST Inclusive + Freight - pricing quoted in Australia Dollars  $1525.00 - GST Inclusive + Freight - pricing quoted in Australia Dollars  $1825.00 - GST Inclusive + Freight - pricing quoted in Australia Dollars  $1625.00 - GST Inclusive + Freight - pricing quoted in Australia Dollars  $1925.00 - GST Inclusive + Freight - pricing quoted in Australia Dollars Aggressive Auto Panels do not design or build products based on price alone We build them based on Quality Workmanship We could supply our products cheaper but we would have to make cuts somewhere in producing the product to make them cheaper. We had looked at many avenues in producing our products and our decision to have Western Boat Repairs to manufacure our products was made entirely on Quality. The feedback we get from our customers has been very positive but where we standout above the rest, is the comments from the Panel Builders and Painters who have worked on our products. The best Fibreglass product we have had to work with - the quality of the fibreglassing is top of the line and the finish is just great Aggressive Auto Panel Products are Manufactured by WBR specialise in the following Services 12 volt Electrical - Gelcoat Repairs - Custom Modifications - Transom and Floor Rebuilds Insurance Work  -  Maintenance - Automotive Fibreglassing - Equipment Installation Pattern and Mould Making - Boat Building - Automotive - Boat Repairs